|
 |
Lift'N Roll The
Lift'N Roll System consists of two short hand trucks which can be
used to move machines and other large and heavy items.
Operation is simple. You strap our two-unit Lift'N roll hand trucks
on the opposite sides of your machine. The with a few twists of
the wrist, the machine is easily lifted above the ground, automatically
locked in place, and you are you are ready to roll to final placement.
They can also be used to"clam shell" machines and other
wide loads through a tight doorway. Simpley open the machine door
and run the strap behind it. When you have finished the "clam
shell" part of the move, you may gently lower the machine to
the ground, and re-strap the load with the machine door closed.
Floor clearance of 1/8" to 4 1/2' is possible with our hydrailis
rams to insure the operator being able to clear low doorways or
difficult thresholds. And, you can gently set the load down without
damaging the floors. You're gonna love its smooth operation. Available
in 1500 pound capacity.
|
 |
| |
 |
STEP RIDER The
Cadillac of stair climbers recently got better. We offer models
capable of moving up to 3500 pounds. Model 1800 is available in
AC/DC and can be easily changed from one power source to the other
even in the middle of a stair move.
When the "Quad Pods", a set of 4 wheel-arms, are extended
downward from the main frame, the Step Rider functions as a handtruck
and rolls on 4 wheels, carring the machine at an angle with no weight
on the operator.
It will carry your machines up any number of flights, and easily
turn those tight landings with no more than two men. (If the landings
are too small for your macine, we have the answer to that problem
as well, they're called "Expanda" Landings.) Remember,
if you can't turn the landing, you can't complete the move!
Here's a feature you're gonna love! The Step Rider will lay the
load down on the stairs for you, all you have to do is flick the
remote power switch. Step Rider is always perfectly balanced so
the operator carries little or no weight.
|
 |
| |
 |
VMS Designed specifically to
take large or tall loads through low doorways, the VMS has easiest
breakbak of any handtruck.
It looks somewhat like a handtruck, but unlike any handtruck you're
ever seen. With its various sets of adjustable wheel arms, and swivel
dolly, it allows the operator to pivot on a dime, hop 1 to 3 steps,
and move machines from vertical or horizontal position, or almost
any angle in between. Its wheel arms, and wheel- base width can
be adjusted to accommodate narrow sidewalks, and it always rolls
on four 6 inch wheels whether on the level or an incline.
Best of all, it takes tall machines through doors WITHOUT the operator
having to carry any of the weight and there is no danger of the
load faling on him.
|
 |
|
|
