DS2500 LED Light Kit
D&S Vending, Inc. is currently using the 2nd wave of LED lighting technology.
Our LED strips utilize only 55-65% of their capacity enabling them to last up to
10 years. They consume only 11 Watts of power, resulting in up to 67% energy
savings compared with standard fluorescent bulbs. In addition, our LEDs when
compared to our competitor’s products will save over 50% in energy costs.
This universal LED light kit works on most machines with minimal installation time.
Included in the kit are two 36” LED pre-wired for MDB aluminum light strips for
most current or converted machines, a 110 volt power adaptor and 6 mounting
brackets.
The LED strips can be mounted using either of these methods
After Disconnecting From Power Source:
-
Use the convenient heavy duty magnets (already attached) and mount to the metal
along the glass: No tools required.
-
Plug into existing MDB connection by coin changer.
Or
-
Using a screwdriver remove screws holding exisiting vertical metal glass trim 1 at a time.
-
Attach mounting bracket to LED strip and mount to vertical glass trim reusing
the screw removed in step 1, using up to 3 mounting brackets per LED strip.
-
Plug into existing MDB connection by coin changer.
The brackets will work on any machine so you can angle the LEDs in any direction.
Should you have any questions about installation, please call us at 800-445-8363
and ask for the parts department.
Specifications
| Light Source |
132pcs Through Hole LED |
| Color Temperature |
Red, Green, Blue |
| Lumen Output |
528/660 lm |
| Beam Angle |
90° |
| Color Rendering Index |
CRI > 72 |
| Effective Lifetime |
> 50,000 hrs (70% Lumen Maintenance) |
| Mechanical Characteristics |
| Method of Installation |
Magnets and/or fixed by clips and screws |
| Dimension |
36”(L) x 0.95”(W) x 0.39(H) |
| Protection Rating |
IP65 or IP67 |
| Electrical Characteristics |
| Lamp Wattage |
11 W |
| Input Voltage |
12VDC / 24VDC |
| Temperature Range |
| Storage Temperature |
-40°F to 122°F |
| Working Temperature |
0 to 104°F (at room temperature 77°F) |
Standard Fluorescent runs at 30 Watts
Competitor A LED runs at 35 Watts Competitor B LED runs at 23 & 26 Watts
D&S Vending’s LED runs at 11 Watts
For National Snack Machines
If you are using this on a National 147/148/157/158/167/168 Glassfront
snack machine, you MUST use the enclosed power supply!!!
TURN OFF MACHINE
1.Plug the power supply into the female plug adaptor (included).
2.Unplug the harness with the white 2 pin plug which comes up from the bottom of the door.
This is the 110 volt line going to the existing bulb fixture.
3.Take the harness out of the clamps that hold it in place all the way down to the bottom of the door.
4.Plug in the power supply with the adaptor end into the white 2 pin plug and then plug the MDB
plug on the other end of the power supply to the LED Kit.
5.Use a wire tie or clamp to attach power supply and extra wires where you want either on the
bottom of the door or the bottom left corner of the cabinet.
6. Mount the LED Kit (refer to top of page)
DO NOT tap into the line coming out of the ballast!!!